Wren & Cuff Two Five

Wren and Cuff Two Five - 25V Boost / Overdrive
The Wren and Cuff Two Five Boost and Overdrive pedal uses a special circuit design with a Charge Pump for 25V operation with a standard 9V input. 25V gives the pedal a lot of headroom, a wide dynamic range, more output and an open character. The response is extremely dynamic and the overall feel is very different from other overdrive pedals. The EQ section is structured like the tone stack on vintage amplifiers, where the individual controls interact with each other. For example, turning down the highs control not only dampens the highs, but also slightly emphasizes the basses. This interplay of the controls enables an incredibly wide range of possible sounds that goes far beyond the classic high-pass / low-pass setups. The Voice toggle switch selects between two different clipping settings: In the upper setting, two mosfet transistors and a germanium diode are used to create a powerful drive with a rich gain. In the lower setting, two LEDs are used for clipping. LED clipping offers a wider dynamic range and a more open, clean sound. The Two Five also has plenty of output - perfect for bringing the front end of the amplifier or other drive pedals into saturation - Boost / Overdrive effect pedal
- internal Charge Pump for 25V operation with a standard 9V input
- large headroom and wide dynamic range
- EQ section is designed like the Tone Stack on vintage amplifiers, where the individual controls interact with each other
- Voice toggle switch selects between two different clipping settings (Mosfet/Germanium clipping for full, rich gain or LED clipping for a more open, clean sound)
- high output, to bring the front end of the amplifier into a natural saturation
- JRC3404 Op-Amp
- True Hard-Wire Bypass
- Controls for Volume, Gain, Lows, Mids, Highs
- Voice toggle switch
- Bypass footswitch
- Status LED
- Metal housing
- 6,3 mm mono jack input / output
- Power supply via optional 9V DC power adapter, 2.1 x 5.5 mm barrel plug, polarity (-) inside (battery is not included)
- Battery operation not supported
- Current consumption 35 mA
- Dimensions (L x W x H) 121 x 65 x 40 mm
- Weight 284 g
- Made in USA
This text has been automatically translated and may contain errors.
| Safety and warning information | Die für das Produkt geltenden Sicherheits- und Warnhinweise sind in der Bedienungsanleitung des Produkts aufgeführt. |
|---|---|
| manufacturer information | Warwick GmbH & Co Music Equipment Gewerbepark 46 08258 Markneukirchen GERMANY info@warwick.de |
Wren and Cuff Two Five - 25V Boost / Overdrive
The Wren and Cuff Two Five Boost and Overdrive pedal uses a special circuit design with a Charge Pump for 25V operation with a standard 9V input. 25V gives the pedal a lot of headroom, a wide dynamic range, more output and an open character. The response is extremely dynamic and the overall feel is very different from other overdrive pedals. The EQ section is structured like the tone stack on vintage amplifiers, where the individual controls interact with each other. For example, turning down the highs control not only dampens the highs, but also slightly emphasizes the basses. This interplay of the controls enables an incredibly wide range of possible sounds that goes far beyond the classic high-pass / low-pass setups. The Voice toggle switch selects between two different clipping settings: In the upper setting, two mosfet transistors and a germanium diode are used to create a powerful drive with a rich gain. In the lower setting, two LEDs are used for clipping. LED clipping offers a wider dynamic range and a more open, clean sound. The Two Five also has plenty of output - perfect for bringing the front end of the amplifier or other drive pedals into saturation - Boost / Overdrive effect pedal
- internal Charge Pump for 25V operation with a standard 9V input
- large headroom and wide dynamic range
- EQ section is designed like the Tone Stack on vintage amplifiers, where the individual controls interact with each other
- Voice toggle switch selects between two different clipping settings (Mosfet/Germanium clipping for full, rich gain or LED clipping for a more open, clean sound)
- high output, to bring the front end of the amplifier into a natural saturation
- JRC3404 Op-Amp
- True Hard-Wire Bypass
- Controls for Volume, Gain, Lows, Mids, Highs
- Voice toggle switch
- Bypass footswitch
- Status LED
- Metal housing
- 6,3 mm mono jack input / output
- Power supply via optional 9V DC power adapter, 2.1 x 5.5 mm barrel plug, polarity (-) inside (battery is not included)
- Battery operation not supported
- Current consumption 35 mA
- Dimensions (L x W x H) 121 x 65 x 40 mm
- Weight 284 g
- Made in USA
This text has been automatically translated and may contain errors.
Wren and Cuff Two Five - 25V Boost / Overdrive
The Wren and Cuff Two Five Boost and Overdrive pedal uses a special circuit design with a Charge Pump for 25V operation with a standard 9V input. 25V gives the pedal a lot of headroom, a wide dynamic range, more output and an open character. The response is extremely dynamic and the overall feel is very different from other overdrive pedals. The EQ section is structured like the tone stack on vintage amplifiers, where the individual controls interact with each other. For example, turning down the highs control not only dampens the highs, but also slightly emphasizes the basses. This interplay of the controls enables an incredibly wide range of possible sounds that goes far beyond the classic high-pass / low-pass setups. The Voice toggle switch selects between two different clipping settings: In the upper setting, two mosfet transistors and a germanium diode are used to create a powerful drive with a rich gain. In the lower setting, two LEDs are used for clipping. LED clipping offers a wider dynamic range and a more open, clean sound. The Two Five also has plenty of output - perfect for bringing the front end of the amplifier or other drive pedals into saturation - Boost / Overdrive effect pedal
- internal Charge Pump for 25V operation with a standard 9V input
- large headroom and wide dynamic range
- EQ section is designed like the Tone Stack on vintage amplifiers, where the individual controls interact with each other
- Voice toggle switch selects between two different clipping settings (Mosfet/Germanium clipping for full, rich gain or LED clipping for a more open, clean sound)
- high output, to bring the front end of the amplifier into a natural saturation
- JRC3404 Op-Amp
- True Hard-Wire Bypass
- Controls for Volume, Gain, Lows, Mids, Highs
- Voice toggle switch
- Bypass footswitch
- Status LED
- Metal housing
- 6,3 mm mono jack input / output
- Power supply via optional 9V DC power adapter, 2.1 x 5.5 mm barrel plug, polarity (-) inside (battery is not included)
- Battery operation not supported
- Current consumption 35 mA
- Dimensions (L x W x H) 121 x 65 x 40 mm
- Weight 284 g
- Made in USA
This text has been automatically translated and may contain errors.
| Safety and warning information | Die für das Produkt geltenden Sicherheits- und Warnhinweise sind in der Bedienungsanleitung des Produkts aufgeführt. |
|---|---|
| manufacturer information | Warwick GmbH & Co Music Equipment Gewerbepark 46 08258 Markneukirchen GERMANY info@warwick.de |
Wren and Cuff Two Five - 25V Boost / Overdrive
The Wren and Cuff Two Five Boost and Overdrive pedal uses a special circuit design with a Charge Pump for 25V operation with a standard 9V input. 25V gives the pedal a lot of headroom, a wide dynamic range, more output and an open character. The response is extremely dynamic and the overall feel is very different from other overdrive pedals. The EQ section is structured like the tone stack on vintage amplifiers, where the individual controls interact with each other. For example, turning down the highs control not only dampens the highs, but also slightly emphasizes the basses. This interplay of the controls enables an incredibly wide range of possible sounds that goes far beyond the classic high-pass / low-pass setups. The Voice toggle switch selects between two different clipping settings: In the upper setting, two mosfet transistors and a germanium diode are used to create a powerful drive with a rich gain. In the lower setting, two LEDs are used for clipping. LED clipping offers a wider dynamic range and a more open, clean sound. The Two Five also has plenty of output - perfect for bringing the front end of the amplifier or other drive pedals into saturation - Boost / Overdrive effect pedal
- internal Charge Pump for 25V operation with a standard 9V input
- large headroom and wide dynamic range
- EQ section is designed like the Tone Stack on vintage amplifiers, where the individual controls interact with each other
- Voice toggle switch selects between two different clipping settings (Mosfet/Germanium clipping for full, rich gain or LED clipping for a more open, clean sound)
- high output, to bring the front end of the amplifier into a natural saturation
- JRC3404 Op-Amp
- True Hard-Wire Bypass
- Controls for Volume, Gain, Lows, Mids, Highs
- Voice toggle switch
- Bypass footswitch
- Status LED
- Metal housing
- 6,3 mm mono jack input / output
- Power supply via optional 9V DC power adapter, 2.1 x 5.5 mm barrel plug, polarity (-) inside (battery is not included)
- Battery operation not supported
- Current consumption 35 mA
- Dimensions (L x W x H) 121 x 65 x 40 mm
- Weight 284 g
- Made in USA
This text has been automatically translated and may contain errors.
Product recommendations could not be loaded.
